Menu
slit and cut machine,
machine can only slit width, machine can only cut length to pieces, machine can slit width and cut length .
This machine is the accessorial equipment for roll forming machine which is used to slit coil sheet to be two pieces or more than two pieces then support it. It has many advantages such as low noisy, stable running, simple operation and nice appearance etc.
This machine consists of transmission, guiding device, covering film device, slitting device, cutting device. And the shaft material is High grade No.45 carbon wrought steel，which can improve the integrated mechanic feature of the shaft, the material of slitter is Cr12 mould steel with quenched treatment which has strong strength and hardness to slit the coil sheet.
Suitable coil width: 1219-1250mm
Suitable coil thickness: 0.3~0.7mm
Yield strength: 235-345Mpa
The parameters of sheet coil: Inner diameter φ508
Max. Width 1250mm
Cutting device: Max.Width is1250mm; cutter material is Cr12 mould steel.
Slitting device: 5 pieces of cutter, cutter material is Cr12 mould steel.
Slitted strip width: width specification is adjustable but it can’t be recoiled;
Min width is 100mm.
Length tolerance +/-1mm in 3M in length
Slitting speed: about 8M/min
Motor power: slitter power 5.5KW
Hydraulic motor power 5.5KW
Cutting style cut to length automatically.
Controller Mitsubishi PLC
Power source: 380V/3phase/50Hz（according to customers’ requirement)
Install the coil into uncoiler coil sheet guiding and Filming
slitting the sheet to be pieces cutting to set length Supporter
5 ton manual decoiler 1 set
Guiding Equipment 1set
Leveling device 1 set
Covering film device 1 set
Cutting Equipment 1set
Slitting equipment 1set
Hydraulic Station 1pc
PLC Control Panel 1pc
here is flat bar cut machine for material width 25-150mm, thickness 2.0-3.5mm, also machine with function of round corner,
therefore , both side of material will not cut hand
No relate news.